Check items to add to the cart or select all
Riding on the waves of the very popular Arduino USB board is this small prototyping shield. Originally spawned with collaboration between the folks at SFE and ITP @ NYU, the ProtoShield mates with the Arduino USB board and gives the user a small soldering area, two general LEDs, access to a BlueSMiRF socket, a general push button switch, and most important of all - the Arduino reset switch is brought to the top level.
This comes in kit form and must be soldered together by the end user. All soldering is through-hole (relatively easy) but always check your component orientation before soldering!
Kit Includes:
1 x ProtoShield bare PCB
2 x Stackable Headers 6-pin
2 x Stackable Headers 8-pin
2 x 5mm Basic Yellow LEDs
2 x 330 Ohm resistors
1 x 10k resistor
2 x Momentary push buttons
2 x 0.1uF Ceramic Capacitors
This comes in kit form and must be soldered together by the end user. All soldering is through-hole (relatively easy) but always check your component orientation before soldering!
Kit Includes:
1 x ProtoShield bare PCB
2 x Stackable Headers 6-pin
2 x Stackable Headers 8-pin
2 x 5mm Basic Yellow LEDs
2 x 330 Ohm resistors
1 x 10k resistor
2 x Momentary push buttons
2 x 0.1uF Ceramic Capacitors