Development Board with Onboard Programmer

Product Description

Description: This board is everything you need for getting started with PIC microcontrollers. It has an on board power supply voltage regulator circuit, microcontroller's reset circuit, 20 MHz crystal oscillator circuit, I2C accessible EEPROM memory, RS232 serial port interface, and In-Circuit-Serial-Programming (ICSP) on the second port. This is an excellent feature that allows you to burn and run without ever having to pull the chip or change cables. New model 'D' has an ICSP header. The PG4D can now be used as a programmer - functionally the same as the PIC-PG1 or PG2C.

Caution: The programmer may not work with low power serial interfaces - i.e. laptop or notebook serial ports. USB to serial cables have also not been proven to work.

• 
  FR-4, 1.5 mm (0.062"), double side green solder mask, white silkscreen component mark


• 
  DIL18 pin microcontroller socket


• 
  Voltage regulator 78L05 and filtering capacitors


• 
  Crystal oscillator circuit 20MHz


• 
  I2C EEPROM 24LC08 or larger


• 
  Reset circuit


• 
  Two RS232 DB9 connectors


• 
  RS232 interface circuit - good for debugging to hyper-terminal


• 
  RS232 Serial Port Programmer


• 
  Extension on board slot 14 pins for RA0-RA3, RB0-RB7, TMR, MCLR


• 
  Gird 100 mils


• 
  GND bus


• 
  Four mounting holes 3.3 mm (0.13")

Documents:

• 
  Schematic


• 
  User's Guide


• 
  Tutorial

Dimensions: 2.4x3.0" (61x76mm)

Software: ICPROG by Bonny Gijzen. It's the best software for serial port programmers we've seen - and it's free!

WinPic - Great new software by Wolfgang "Wolf" Büscher. Supports all the popular flash PICs, as well as many of the newly released PICs!

Supported PICs: 16F628A, 16F88, 16F84A