Development Board for AT90USB162 for USB

Product Description

Description: AT90USB162 is the easiest way to add USB functionality to your next device, Atmel provide free open source HID (mouse, keyboard) and CDC (USB-to-RS232) code.



The board has a USB connector, Joystick, RS232, SD-MMC card, Audio output, ICSP connector and extension connector. All AT90USB162 comes from Atmel pre-programmed with the  bootloader which allow code to be programmed inside the chip without any external programmer, just download the FLIP software from Atmel web site and load your HEX code inside AT90USB162. To enter the bootloader mode you shoud press and hold HWB button, then press and release RST button.



Note: If you prefer to use ICSP programmer, only the AVR-ISP-MK2 is supporting AT90USB162 as they are pretty new devices. Probably AVR Dude will add support later, but for the moment you can't use AVR-PG1 or AVR-PG2 for ICSP programming. Also, the AT90USB162 supports only debug Wire not JTAG so to debug it you will need the AT-JTAGICE-MK2.



Features:

• 
  AT90USB162 microcontroller with 16KB Flash, 512B RAM, 512B EEPROM


• 
  ICSP 5x2 pin connector for in-circuit programming with AVR-ISP-MK2 (you generally don't need to use ICSP as you can program via USB)


• 
  Debug Wire could be performed by 3 wires connected to ICSP (VCC, GND, RST signals)


• 
  USB 2.0 Full speed connector


• 
  RS232 driver and connector


• 
  SD-MMC card connector


• 
  Audio out 3.5 mm jack connector


• 
  Extension connector with AVR port signals


• 
  Status LED


• 
  Joystick


• 
  User button HWB (can be used to enter bootloader mode after reset)


• 
  Reset button


• 
  Takes power from USB. No need for external adapter


• 
  External power supply and voltage regulator if USB can't provide enough power


• 
  Quartz crystal oscillator circuit: 8MHz


• 
  Extension pin headers for each uC pin


• 
  Four mounting holes 3.3 mm (0.13")


• 
  FR-4, 1.5 mm (0,062"), green soldermask, white silkscreen component print

Dimensions: 100x80 mm (3.9x3.15")



Documents:

• 
  Users Manual


• 
  Schematic


• 
  Atmel USB FLIP Software


• 
  AVR-USB-STK HID mouse demo code C source for WinAVR


• 
  AVR-USB-STK CDC virtual COM port C source for WinAVR


• 
  AVR-USB-STK Mass Storage demo C source for WinAVR


• 
  AVR-USB-STK demo C source for WinAVR


• 
  LUFA (MIT Licensed) USB stack from Dean Camera