WIZnet Network Module with Mag Jack - WIZ830MJ

Product Description

Replacement: None. We don't have a direct replacement for this board. This page is for reference only.

Description: WIZnet's WIZ830MJ is essentially a breakout board for their W5300 TCP/IP hardwired chip. Also featured on the board is an RJ-45 MagJack connector (RJ45 with X’FMR). It can be used as a component and little effort is required to interface to the W5300. The WIZ830MJ is an ideal option for users who want a simple solution to adding TCP/IP capability to their project.



For detailed information on implementation of Hardware TCP/IP, refer to the W5300 Datasheet.



Features:

• 
  Integrated W5300 TCP/IP hardware chip and MagJack connector


• 
  All pins of the W5300 broken out to 0.1" pitch headers


• 
  Supports 10/100 Base TX


• 
  Operates 3.3V with 5V I/O signal tolerance


• 
  High network performance: up to 50Mbps


• 
  Supports half/full duplex operation


• 
  Supports auto-negotiation and auto cross-over detection


• 
  IEEE 802.3/802.3u Compliance


• 
  Supports network status indicator LEDs


• 
  Includes Hardware Internet protocols: TCP, IP Ver.4, UDP, ICMP, ARP, PPPoE, IGMP


• 
  Includes Hardware Ethernet protocols: DLC, MAC


• 
  Supports 8 independent connections simultaneously


• 
  Supports MCU bus Interface


• 
  Supports Direct/Indirect mode bus access


• 
  Supports 16/8 bit data bus width


• 
  Supports memory-to-memory DMA (only 16bit Data bus width & slave mode)


• 
  Supports Socket API for easy application programming


• 
  Supports hybrid TCP/IP stack(software and hardware TCP/IP stack)


• 
  Supports PPPoE connection (with PAP/CHAP Authentication mode)


• 
  More flexible allocation internal TX/RX memory according to application throughput


• 
  Interfaces with two 2.54mm pitch 2 x 14 header pin

Dimensions:

• 
  Board: 53.3x34.0x19.5 mm (W x D x H)

Documents:

• 
  Datasheet


• 
  Schematic


• 
  W5300 Datasheet


• 
  WIZnet Product Page